Launch track
Encyclopedia
The launch track is the section of a launched roller coaster
Launched roller coaster
The launched roller coaster is a modern form of roller coaster which has increased in use in the last decade. In place of a traditional chain lift, the launched coaster initiates a ride with high amounts of acceleration via one or series of Linear Induction Motors , Linear Synchronous Motors ,...

 in which the train
Train (roller coaster)
A roller coaster train or car describes the vehicle which transports passengers around a roller coaster's circuit. More specifically, a roller coaster train is made up of two or more "cars" which are connected by some sort of specialized joint. It is called a "train" because the cars follow one...

 is accelerated to its full speed in a matter of seconds. A launch track is always straight and is usually banked upwards slightly, so that a train would roll backwards to the station in the event of a loss of power.

A launch track serves the same basic purpose as a lift hill
Lift hill
A lift hill, or chain hill, is often the initial upward-sloping section of track on a typical roller coaster that initially transports the roller coaster train to an elevated point or peak in the roller coaster ride...

 - providing power to the train - but accomplishes it in an entirely different manner. A lift hill gives the train potential energy
Potential energy
In physics, potential energy is the energy stored in a body or in a system due to its position in a force field or due to its configuration. The SI unit of measure for energy and work is the Joule...

 by raising it to the highest point in the track (and not significantly accelerating it). A launch track gives the train kinetic energy
Kinetic energy
The kinetic energy of an object is the energy which it possesses due to its motion.It is defined as the work needed to accelerate a body of a given mass from rest to its stated velocity. Having gained this energy during its acceleration, the body maintains this kinetic energy unless its speed changes...

 by accelerating it to the maximum designed speed (while not significantly raising it).

A launch track normally includes some form of brakes
Brake run
A brake run on a roller coaster is any section of track meant to slow or stop a roller coaster train. Brake runs may be located anywhere along the circuit of a coaster and may be designed to bring the train to a complete halt or to simply adjust the train's speed...

. Depending on the type of coaster, these brakes may be used in every run of the coaster (this is normally found on a Shuttle roller coaster
Shuttle roller coaster
A shuttle roller coaster is any roller coaster that ultimately does not make a complete circuit, but rather reverses at some point throughout its course and traverses the same track backwards...

 where the launch track also serves as the main brake run
Brake run
A brake run on a roller coaster is any section of track meant to slow or stop a roller coaster train. Brake runs may be located anywhere along the circuit of a coaster and may be designed to bring the train to a complete halt or to simply adjust the train's speed...

) or they may only come into play when a rollback
Rollback (roller coaster)
A rollback occurs on a launched roller coaster when the train is not launched fast enough to reach the top of the tower. It will roll backwards down the tower, and will be stopped by brakes on the launch track. Any roller coaster on which it is possible for a rollback to occur will have these brakes...

 occurs, normally on a complete-circuit coaster such as Top Thrill Dragster
Top Thrill Dragster
Top Thrill Dragster is a steel, Hydraulic-launched roller coaster located at Cedar Point in Sandusky, Ohio. It was the first "Strata Coaster", loosely defined as a complete circuit coaster that is over tall. It was built by Intamin and debuted to the public on May 4, 2003...

 and Kingda Ka
Kingda Ka
Kingda Ka is a roller coaster located at Six Flags Great Adventure in Jackson, New Jersey, USA. It is the world's tallest roller coaster, and was the world's fastest until Formula Rossa opened in November 2010. The train is launched by a hydraulic launch mechanism to in 3.5 seconds. At the end of...

. In either case, the brakes are retracted to allow trains to launch, and are engaged at all other times.

LIM/LSM

LIM/LSM launch tracks have many (often more than 200) linear motor
Linear motor
A linear motor is an electric motor that has had its stator and rotor "unrolled" so that instead of producing a torque it produces a linear force along its length...

s on both sides of the launch track. The train on this type of coaster has metal fins mounted to its sides to facilitate launching. A magnetic field is created by the LIMs on the track, which attract the car and send it forward. The next LIM on the track is magnetized, and the previous one loses its field. This continually attracts the car forward until it reaches the end of the launch track at full speed.

Hydraulic

A hydraulic launch track has a trough running along its center, a "catch car" that connects to the train for launching travels through this trough. The catch car is connected to a cable
Wire rope
thumb|Steel wire rope Wire rope is a type of rope which consists of several strands of metal wire laid into a helix. Initially wrought iron wires were used, but today steel is the main material used for wire ropes....

 loop that runs along the entire length of the launch track, anchored by a pulley wheel at the near end of the track and by the launch motor itself at the far end. The launch motor is located in a small building under the end of the launch track. Only about 2/3 of the length of this type of launch track can be used for launching the train, as the catch car must be stopped after it disengages from the train. This type of propulsion is capable of catapulting a train to very high speeds, yet is only used mostly by Intamin AG
Intamin AG
Intamin Worldwide is a designing and manufacturing company in Wollerau, Switzerland. It is best known for creating thrill rides and roller coasters worldwide. The U.S. division of the company is located in Glen Burnie, Maryland, and is headed by Sandor Kernacs. The Intamin brand name is an...

, and less abundantly used by Vekoma
Vekoma
Vekoma Rides Manufacturing B.V. is a roller coaster and thrill ride designer with its facilities based in the Netherlands. The company was founded in 1926 by Hendrik op het Veld under the name "Veld Koning Machinefabriek" and had first manufactured agricultural machinery and mining equipment...

, in their Accelerator coaster
Accelerator Coaster
The Accelerator Coaster is Intamin AG's term for their hydraulically-launched roller coaster model. These models are the tradename for some of the fastest rides on earth....

s and Motorbike coasters, respectively.

Friction Wheel

A friction wheel launch consists of a series of high speed drive tires used in succession to propel the train forward. An example of a friction wheel launch is the Incredible Hulk Coaster at Universal's Islands of Adventure
Islands of Adventure
Universal's Islands of Adventure is a theme park located in Orlando, Florida. It opened May 28, 1999 as part of an expansion that, along with CityWalk Entertainment District, the Portofino Bay Hotel, and Hard Rock hotel, converted Universal Studios Florida into the Universal Orlando Resort...

. The train begins to climb the lift hill
Lift hill
A lift hill, or chain hill, is often the initial upward-sloping section of track on a typical roller coaster that initially transports the roller coaster train to an elevated point or peak in the roller coaster ride...

 at a normal speed, and begins to accelerate half-way up the hill.

Flywheel

Many shuttle loop
Shuttle roller coaster
A shuttle roller coaster is any roller coaster that ultimately does not make a complete circuit, but rather reverses at some point throughout its course and traverses the same track backwards...

 roller coasters have a flywheel
Flywheel
A flywheel is a rotating mechanical device that is used to store rotational energy. Flywheels have a significant moment of inertia, and thus resist changes in rotational speed. The amount of energy stored in a flywheel is proportional to the square of its rotational speed...

 launch mechanism. Rotational energy is stored in the flywheel, which then catches on a cable attached to the train. The flywheel releases its energy to propel the train forward.

Counterweight

Counterweight launch mechanisms are used on some shuttle loops. The trains are launched by dropping a large counterweight attached to a cable. The cable then drives the train forward.

Cable

Disneyland Paris' Space Mountain uses this system. The train arrives at an incline and stops and hooks on to the pulley/catapult. The train is then launched up the hill and the cable falls back to the bottom.
The source of this article is wikipedia, the free encyclopedia.  The text of this article is licensed under the GFDL.
 
x
OK