Control reversal
Encyclopedia
Control reversal is an adverse effect on the controllability of aircraft
Aircraft
An aircraft is a vehicle that is able to fly by gaining support from the air, or, in general, the atmosphere of a planet. An aircraft counters the force of gravity by using either static lift or by using the dynamic lift of an airfoil, or in a few cases the downward thrust from jet engines.Although...

. The flight controls reverse themselves in a way that is not intuitive, so pilots may not be aware of the situation and therefore provide the wrong inputs; in order to roll to the left, for instance, they have to push the control stick to the right, the opposite of the normal direction.

Causes

There are several causes for this problem: pilot error, effects of high-speed flight
High-speed flight
In high-speed flight the assumptions of incompressibility of the air used in low-speed aerodynamics no longer apply. In subsonic aerodynamics, the theory of lift is based upon the forces generated on a body and a moving gas in which it is immersed...

, incorrectly connected controls, and various coupling forces on the aircraft.

Equipment malfunction

Equipment failure may cause flight controls to behave unexpectedly, for example the rudder reversal experienced onboard United Airlines Flight 585
United Airlines Flight 585
United Airlines Flight 585 was a scheduled domestic passenger airline flight from the now-decommissioned Stapleton International Airport in Denver to Colorado Springs Municipal Airport in Colorado Springs, Colorado....

.

Pilot error

Pilot error
Pilot error
Pilot error is a term used to describe the cause of an accident involving an airworthy aircraft where the pilot is considered to be principally or partially responsible...

 is the most common cause of control reversal. In unusual attitudes it is not uncommon for the pilot to become disoriented and start feeding in incorrect control movements in order to regain level flight. This is particularly common when using helmet mounted display systems, which introduce graphics that remain steady in the pilot's view, notably when using a particular form of attitude display known as an inside-out display.

Incorrectly connected controls

Incorrectly connected controls are another common cause of this problem. It is a recurring problem after maintenance on aircraft, notably homebuilt designs that are being flown for the first time after some minor work. However it is not entirely uncommon on commercial aircraft, and has been the cause of several accidents including the death of Avro designer Roy Chadwick
Roy Chadwick
Roy Chadwick, CBE, FRAeS was an aircraft designer for Avro. Born at Marsh Hall Farm, Farnworth in Widnes, son of the mechanical engineer Charles Chadwick, he was the Chief Designer for the Avro Company and was responsible for practically all of their aeroplane designs...

.

Wing twist

Another manifestation of the problem occurs when the amount of airflow over the wing
Wing
A wing is an appendage with a surface that produces lift for flight or propulsion through the atmosphere, or through another gaseous or liquid fluid...

 becomes so great that the force generated by the aileron
Aileron
Ailerons are hinged flight control surfaces attached to the trailing edge of the wing of a fixed-wing aircraft. The ailerons are used to control the aircraft in roll, which results in a change in heading due to the tilting of the lift vector...

s is enough to twist the wing itself, due to insufficient torsional
Torsion (mechanics)
In solid mechanics, torsion is the twisting of an object due to an applied torque. In sections perpendicular to the torque axis, the resultant shear stress in this section is perpendicular to the radius....

 stiffness of the wing structure. For instance when the aileron is deflected upwards in order to make that wing move down, the wing twists in the opposite direction. The net result is that the airflow is directed down instead of up and the wing moves upward, opposite of what was expected. This form of control reversal is often lumped in with a number of "high speed" effects as compressibility.

Wright Brothers glider

The Wright Brothers
Wright brothers
The Wright brothers, Orville and Wilbur , were two Americans credited with inventing and building the world's first successful airplane and making the first controlled, powered and sustained heavier-than-air human flight, on December 17, 1903...

 suffered a form of control reversal, normally referred to as adverse yaw
Adverse yaw
Adverse yaw is a yaw moment on an aircraft which results from an aileron deflection and a roll rate, such as when entering or exiting a turn. It is called "adverse" because it acts opposite to the yaw moment needed to execute the desired turn. Adverse yaw has three mechanisms, listed below in...

. In their 1902 glider they continued to encounter a problem where the glider would roll in one direction but yaw in the reverse direction, then spin into the ground. They eventually cured the problem by adding a movable rudder
Rudder
A rudder is a device used to steer a ship, boat, submarine, hovercraft, aircraft or other conveyance that moves through a medium . On an aircraft the rudder is used primarily to counter adverse yaw and p-factor and is not the primary control used to turn the airplane...

 system, now found on all aircraft.

The root cause of the problem was dynamic. Warping the wing did what was expected in terms of lift, thereby rolling the plane, but also had an effect on drag. The result was that the upward-moving wing was dragged backwards, yawing the glider. If this yaw was violent enough, the additional speed on the lower wing as it was driven forward would make it generate more lift, and reverse the direction of the roll.

Supermarine Spitfire

Due to the unusually high speeds at which the Supermarine Spitfire
Supermarine Spitfire
The Supermarine Spitfire is a British single-seat fighter aircraft that was used by the Royal Air Force and many other Allied countries throughout the Second World War. The Spitfire continued to be used as a front line fighter and in secondary roles into the 1950s...

 could dive, this problem of aileron
Aileron
Ailerons are hinged flight control surfaces attached to the trailing edge of the wing of a fixed-wing aircraft. The ailerons are used to control the aircraft in roll, which results in a change in heading due to the tilting of the lift vector...

 reversal became apparent when it was wished to increase the lateral maneuverability (rate of roll) by increasing the aileron area. The aircraft had a wing designed originally for an aileron reversal airspeed of 580 mph, and any attempt to increase the aileron area would have resulted in the wing twisting when the larger ailerons were applied at high speed, the aircraft then rolling in the opposite direction to that intended by the pilot. The problem of increasing the rate of roll was temporarily alleviated with the introduction of "clipped" wing tips (to reduce the aerodynamic load on the tip area, allowing larger ailerons to be used) until a new, stiffer wing could be incorporated.
This new wing was introduced in the Mark XXI and had a theoretical aileron reversal speed of 825 mi/h.

Boeing B-47

The Boeing B-47 was speed limited at low altitudes because the large, flexible wings would cancel out the effect of the control surfaces under some circumstances.

Gossamer Condor

Control reversal also affected the Gossamer Condor
Gossamer Condor
-See also:-Further reading:*Morton Grosser. Gossamer Odyssey: The Triumph of Human-Powered Flight. MBI Press, 2004; Dover Publications, Inc., 1991; Houghton Mifflin Co., 1981*Morton Grosser. On Gossamer Wings. York Custom Graphics, 1982...

, the Kremer Prize
Kremer prizes
The Kremer prizes are a series of monetary awards, established in 1959 by the industrialist Henry Kremer, that are given to pioneers of human-powered flight. The competitions and prize awards are administered by the Royal Aeronautical Society's Human Powered Aircraft Group. .The first Kremer prize...

-winning human-powered airplane. When a wing-warping mechanism was tried as a solution to a long-running turning problem, the effect was to turn the airplane in the opposite direction to that expected by conventional airplane knowledge. When the Condor was rigged "conventionally", the inside wing slowed down so much that it settled to the ground. By employing "backwards" wired wing-warping, the inside wingtip angle of attack
Angle of attack
Angle of attack is a term used in fluid dynamics to describe the angle between a reference line on a lifting body and the vector representing the relative motion between the lifting body and the fluid through which it is moving...

was increased so that the added drag slowed that wing while the added lift allowed the airfoil to stay aloft at a slower speed. The tilted canard could then complete the turn.

External links

  • A320 Incident - incorrect maintenance led to reversal of the roll control on the pilot's controls
The source of this article is wikipedia, the free encyclopedia.  The text of this article is licensed under the GFDL.
 
x
OK