Bus-Holder
Encyclopedia
A bus-holder is a weak latch circuit
Electronic circuit
An electronic circuit is composed of individual electronic components, such as resistors, transistors, capacitors, inductors and diodes, connected by conductive wires or traces through which electric current can flow...

 which holds last value on a tri-state bus.

The circuit is basically a delay element with the output connected back to the input through a relatively high impedance. This is usually achieved with two inverters
Inverter (electrical)
An inverter is an electrical device that converts direct current to alternating current ; the converted AC can be at any required voltage and frequency with the use of appropriate transformers, switching, and control circuits....

 connected back to back. The resistor drives the bus weakly; therefore other circuits can override the value of the bus when they are not in tri-state mode.

Bus-holders are used to prevent CMOS gate inputs from getting floating values when they are connected to tri-stated nets. Otherwise both transistors in the gate could get turned on, thus shorting the power supply and ground, which would destroy the CMOS gate. This is prevented by the bus-holder pulling the input to the last valid logic level (0 or 1) on the net. The circuit is usually placed in parallel with the tri-stated net.
The source of this article is wikipedia, the free encyclopedia.  The text of this article is licensed under the GFDL.
 
x
OK