Servo bandwidth
Encyclopedia
Servo bandwidth can be defined as the maximum trackable sinusoidal frequency of amplitude A, with tracking achieved at or before 10% of A amplitude is reached. The servo bandwidth indicates the capability of the servo
to follow rapid changes in the commanded input. It is usually specified as a frequency in Hertz
or radian/sec.
A simple and sound definition can be sought regarding this.
Let us say we want to design a position servo control system with following specifications:
The above definition is not enough to design a practical control system. The definitions above have inherent problems with regard to what amplitude the manufacturer should take to design the servo with 10Hz bandwidth.
If the manufacturer takes the amplitude to be ±20° and rise time for this amplitude to be 0.025 sec (10Hz sinusoid)
and some other manufacturer takes amplitude to be ±50° , the acceleration requirements calculated by two will be very different.
This leads us to understand that giving servo bandwidth alone with no amplitude specification is almost useless. Also defining the bandwidth as per normal bandwidth definition does not help (ambiguity with regard to frequency at which the amplitude should go to 1/ root(2)).
Servomechanism
thumb|right|200px|Industrial servomotorThe grey/green cylinder is the [[Brush |brush-type]] [[DC motor]]. The black section at the bottom contains the [[Epicyclic gearing|planetary]] [[Reduction drive|reduction gear]], and the black object on top of the motor is the optical [[rotary encoder]] for...
to follow rapid changes in the commanded input. It is usually specified as a frequency in Hertz
Hertz
The hertz is the SI unit of frequency defined as the number of cycles per second of a periodic phenomenon. One of its most common uses is the description of the sine wave, particularly those used in radio and audio applications....
or radian/sec.
Explanation
Bandwidth of systems is generally defined to be the frequency at which the system's amplitude is 1/square root (2) times the signal amplitude. But if we apply same logic to servo systems it is difficult to analyze and develop a system to a sufficiently accurate specification. This is because of ambiguity with regard to frequency at which the amplitude should go to 1 / root(2).A simple and sound definition can be sought regarding this.
Let us say we want to design a position servo control system with following specifications:
- Bandwidth: 10Hz
- Allowed amplitude range : ± 50°
The above definition is not enough to design a practical control system. The definitions above have inherent problems with regard to what amplitude the manufacturer should take to design the servo with 10Hz bandwidth.
If the manufacturer takes the amplitude to be ±20° and rise time for this amplitude to be 0.025 sec (10Hz sinusoid)
and some other manufacturer takes amplitude to be ±50° , the acceleration requirements calculated by two will be very different.
This leads us to understand that giving servo bandwidth alone with no amplitude specification is almost useless. Also defining the bandwidth as per normal bandwidth definition does not help (ambiguity with regard to frequency at which the amplitude should go to 1/ root(2)).