A roughing pump is any vacuum pump

Vacuum pump

A vacuum pump is a device that removes gas molecules from a sealed volume in order to leave behind a partial vacuum. The first vacuum pump was invented in 1650 by Otto von Guericke.- Types :Pumps can be broadly categorized according to three techniques:...

 (typically mechanical) used to initially evacuate a vacuum system, as a first stage towards achieving high vacuum

Vacuum

In everyday usage, vacuum is a volume of space that is essentially empty of matter, such that its gaseous pressure is much less than atmospheric pressure. The word comes from the Latin term for "empty". A perfect vacuum would be one with no particles in it at all, which is impossible to achieve in...

 or ultra high vacuum

Ultra high vacuum

Ultra-high vacuum is the vacuum regime characterised by pressures lower than about 10−7 pascal or 100 nanopascals . UHV requires the use of unusual materials in construction and by heating the entire system to 180°C for several hours to remove water and other trace gases which adsorb on the...

. The term "roughing pump" derives from the vacuum range it works in, "rough vacuum", above 1x10^-3 torr

Torr

The torr is a non-SI unit of pressure with the ratio of 760 to 1 standard atmosphere, chosen to be roughly equal to the fluid pressure exerted by a millimetre of mercury, i.e., a pressure of 1 torr is approximately equal to 1 mmHg...

. Pumps that operate in the high vacuum ranges typically don't operate or operate inefficiently at atmospheric pressure

Atmospheric pressure

Atmospheric pressure is the force per unit area exerted into a surface by the weight of air above that surface in the atmosphere of Earth . In most circumstances atmospheric pressure is closely approximated by the hydrostatic pressure caused by the weight of air above the measurement point...

s, whereas pumps that work efficiently at atmospheric pressure usually can't produce a vacuum lower than approximately 1x10^-3 torr.

One consideration for choosing a roughing pump is whether the pump uses lubricating oil that's exposed to the vacuum. This concern of "hydrocarbon backstreaming" where pump oil as a gas makes its way into the vacuum chamber, has led to oil-free pump designs on the market.

Types

Two main types of roughing pumps are oil-sealed roughing pumps or dry roughing pumps. Within the two categories are various kinds of designs with differences among them based on maintenance issues, initial costs, pump lifespan and vacuum level. Early in their manufacture, dry pumps were significantly more expensive than oil-based pumps, however over time the cost gap has closed.

Sources

• The Essentials of a Vacuum System, Hasina Jamal, University of Maryland

External Links

• Comparison of Roughing Pumps, Roy Schmaus, University of Alberta