Power factor (pistol)
Encyclopedia
In competitive practical shooting
, power factor refers to a ranking system for the momentum of pistol cartridges. The power factor is used in competitions sponsored by IPSC
, USPSA
, The Bianchi Cup
, Steel Challenge
, and IDPA
.
The power factor is calculated by multiplying bullet weight (in grains, 7,000 to the pound) by muzzle velocity (in feet per second), then dividing by 1000. As of 2008, a value of 165 or greater is considered major, while values below 165 are minor.
All firearms must have a minimum power factor of 125 for USPSA competition, and virtually anything of 9mm Luger or greater caliber will fit into minor. The minimum power factor is required since less-powerful cartridges have lower recoil and can be fired more quickly; setting a minimum value emphasizes the shooter's skill.
Until a point in the late 1990s, the cut off point for "making major" was 175.
The desire to "make major" is a large part of the popularity of high velocity 9mm cartridges in this type of competition. .38 Super
and other similar cartridges can be loaded to make major power factor. The felt recoil of a 9mm at Major is much the same as it would be for a .45. However, its higher operating pressure (.45: 17,000PSI, .38 Super: 34,000PSI)provides the Super a greater amount of higher-pressure gases to the muzzle brake. Open Division pistols are allowed a muzzle brake, and the re-directed gases act to damped felt recoil and muzzle rise. Other equipment Divisions are not permitted muzzle brakes, (except for Modified) and thus the .38 Super or one of its derivatives are not common outside of those two Divisions.
Major/Minor scoring occurs in USPSA in Open, Limited, Limited 10, Single Stack and Revolver Divisions. In production Division, only Minor is permitted. Use of major ammo will not give any additiona score. In IPSC competitions, Open, Standard, Modified, and Revolver Standard are Major/Minor, and Production is only Minor.
), where the power factor is 165,000. Enhanced Service Revolver division also has a power factor of 165,000.
In all instances, it is up to the competitor to ensure his/her ammunition meets the requirements for the competition or equipment Division. In Division where both Major and Minor are permitted, the shooter must balance the faster shooting with Minor ammunition against the lower scoring.
Effective 1/17/11 the power factor for the stock service revolver division (SSR) was reduced to 105,000 since most factory produced .38 special ammunition available on the market did not meet the previous minimum power factor of 125,000. 1.
, all matches requiring the use of centerfire ammunition must meet or exceed power floor of 120,000, or 120 Power Factor. Ammunition failing the chronograph test out of the competitor's own gun will result in disqualification.
Practical shooting
Practical shooting is a sport which challenges an individual's ability to shoot rapidly and accurately with a full-power handgun, rifle, or shotgun. To do this, shooters take on obstacle-laden shooting courses called stages, some requiring many shots to complete, and others just a few...
, power factor refers to a ranking system for the momentum of pistol cartridges. The power factor is used in competitions sponsored by IPSC
International Practical Shooting Confederation
The International Practical Shooting Confederation is a shooting sport based on the concept of practical shooting. Accuracy, power and speed are all required to achieve a maximum score.-Founding and organization:...
, USPSA
United States Practical Shooting Association
The United States Practical Shooting Association, or USPSA, is the national governing body of one form of Practical shooting in the United States, and is the US Region of the International Practical Shooting Confederation...
, The Bianchi Cup
The Bianchi Cup
The Bianchi Cup is the NRA National Action Pistol Championship, a major Action Pistol tournament held over three days in late May, in Columbia, Missouri at the Green Valley Rifle & Pistol Club. It has the largest purse of any tournament on the action pistol calendar and is the premier action...
, Steel Challenge
Steel Challenge
The Steel Challenge is a speed shooting championship and governed by the Steel Challenge Shooting Association . The competition was founded by Mike Dalton and Mike Fichman. The targets, made of steel, range in size from 10" round plates to 18"x24" square plates...
, and IDPA
International Defensive Pistol Association
The International Defensive Pistol Association , founded in 1996, is an organization based in Berryville, Arkansas, USA that promotes defensive pistol shooting as a sport, using equipment including full-charge service ammunition to solve simulated "real world" self-defense scenarios...
.
IPSC/USPSA Power factor
IPSC and USPSA provide for two power factors, major and minor. The basis for power factor is the assumption that in a real-life encounter, a center hit from either will suffice to end the fight. Lesser-power cartridges will have less effect as the hits occur further from the center. The scoring would thus be: for a center, next scoring area and most-outside scoring area: Major; 5-4-2. Minor; 5-3-1. Poor hits (i.e. less-accurate marksmanship) are penalized, and the lesser cartridge is penalized more.The power factor is calculated by multiplying bullet weight (in grains, 7,000 to the pound) by muzzle velocity (in feet per second), then dividing by 1000. As of 2008, a value of 165 or greater is considered major, while values below 165 are minor.
All firearms must have a minimum power factor of 125 for USPSA competition, and virtually anything of 9mm Luger or greater caliber will fit into minor. The minimum power factor is required since less-powerful cartridges have lower recoil and can be fired more quickly; setting a minimum value emphasizes the shooter's skill.
Until a point in the late 1990s, the cut off point for "making major" was 175.
The desire to "make major" is a large part of the popularity of high velocity 9mm cartridges in this type of competition. .38 Super
.38 Super
The .38 Super or .38 Super Automatic is a pistol cartridge that fires a diameter bullet. The Super was introduced in the late 1920s as a higher pressure loading of the .38 ACP or .38 Auto. The old .38 ACP propelled a bullet at . The improved .38 Super Auto pushed the same bullet at...
and other similar cartridges can be loaded to make major power factor. The felt recoil of a 9mm at Major is much the same as it would be for a .45. However, its higher operating pressure (.45: 17,000PSI, .38 Super: 34,000PSI)provides the Super a greater amount of higher-pressure gases to the muzzle brake. Open Division pistols are allowed a muzzle brake, and the re-directed gases act to damped felt recoil and muzzle rise. Other equipment Divisions are not permitted muzzle brakes, (except for Modified) and thus the .38 Super or one of its derivatives are not common outside of those two Divisions.
Major/Minor scoring occurs in USPSA in Open, Limited, Limited 10, Single Stack and Revolver Divisions. In production Division, only Minor is permitted. Use of major ammo will not give any additiona score. In IPSC competitions, Open, Standard, Modified, and Revolver Standard are Major/Minor, and Production is only Minor.
IDPA Power Factor
The IDPA also has a "power factor", and it is calculated the same way, however there is no scoring distinction between major and minor as in USPSA. A particular IDPA division has a minimum power factor, and the firearm must meet or exceed this minimum to be legal for competition. The minimum power factor is 125,000 (the same as a USPSA power factor of 125) for all divisions except Custom Defensive Pistol (which is restricted to semiautomatics chambered for .45 ACP.45 ACP
The .45 ACP , also known as the .45 Auto by C.I.P., is a cartridge designed by John Browning in 1904, for use in his prototype Colt semi-automatic .45 pistol and eventually the M1911 pistol adopted by the United States Army in 1911.-Design and history:The U.S...
), where the power factor is 165,000. Enhanced Service Revolver division also has a power factor of 165,000.
In all instances, it is up to the competitor to ensure his/her ammunition meets the requirements for the competition or equipment Division. In Division where both Major and Minor are permitted, the shooter must balance the faster shooting with Minor ammunition against the lower scoring.
Effective 1/17/11 the power factor for the stock service revolver division (SSR) was reduced to 105,000 since most factory produced .38 special ammunition available on the market did not meet the previous minimum power factor of 125,000. 1.
NRA Action Pistol
In the Bianchi CupThe Bianchi Cup
The Bianchi Cup is the NRA National Action Pistol Championship, a major Action Pistol tournament held over three days in late May, in Columbia, Missouri at the Green Valley Rifle & Pistol Club. It has the largest purse of any tournament on the action pistol calendar and is the premier action...
, all matches requiring the use of centerfire ammunition must meet or exceed power floor of 120,000, or 120 Power Factor. Ammunition failing the chronograph test out of the competitor's own gun will result in disqualification.