F region
Encyclopedia
The F region of the ionosphere
Ionosphere
The ionosphere is a part of the upper atmosphere, comprising portions of the mesosphere, thermosphere and exosphere, distinguished because it is ionized by solar radiation. It plays an important part in atmospheric electricity and forms the inner edge of the magnetosphere...

 is home to the F layer
Layer
Layer may refer to:* A layer of archaeological deposits in an excavation* A layer hen, a hen raised to produce eggs* Stratum, a layer of rock or soil with internally consistent characteristics...

 of ionization, also called the Appleton layer, after the English physicist Edward Appleton. As with other ionospheric sectors, 'layer' implies a concentration of plasma, while 'region' is the area that contains the said layer. The F region contains ionized gases at a height of around 150–800 km above sea level
Sea level
Mean sea level is a measure of the average height of the ocean's surface ; used as a standard in reckoning land elevation...

, placing it in the Earth’s thermosphere
Thermosphere
The thermosphere is the biggest of all the layers of the Earth's atmosphere directly above the mesosphere and directly below the exosphere. Within this layer, ultraviolet radiation causes ionization. The International Space Station has a stable orbit within the middle of the thermosphere, between...

, a hot region in the upper atmosphere
Atmosphere
An atmosphere is a layer of gases that may surround a material body of sufficient mass, and that is held in place by the gravity of the body. An atmosphere may be retained for a longer duration, if the gravity is high and the atmosphere's temperature is low...

, and also in the heterosphere, where chemical composition varies with height. Generally speaking, the F region has the highest concentration of free electrons and ions anywhere in the atmosphere. It may be thought of as comprising two layers, the F1-and F2-layers.

The F-region is located directly above the E region (formerly the Kennelly-Heaviside layer) and below the protonosphere. It acts as a dependable reflector of radio signals as it is not affected by atmospheric conditions, although its ionic composition varies with the sunspot cycle. It reflects normal-incident frequencies at or below the critical frequency
Critical frequency
In telecommunication, the term critical frequency has the following meanings:* In radio propagation by way of the ionosphere, the limiting frequency at or below which a wave component is reflected by, and above which it penetrates through, an ionospheric layer.* At vertical incidence, the limiting...

 (approximately 10 MHz) and partially absorbs waves of higher frequency.

The F region is the region of the ionosphere which is very important for HF radio wave propagation. This F region is very anomalous in nature.

F1 and F2 Layers

The F1 layer
Layer
Layer may refer to:* A layer of archaeological deposits in an excavation* A layer hen, a hen raised to produce eggs* Stratum, a layer of rock or soil with internally consistent characteristics...

 is the lower sector of the F layer and exists from about 150 to 220 km above the surface of the Earth and only during daylight hours. It is composed of a mixture of molecular ions O2+ and NO+, and atomic ions O+. Above the F1 region, atomic oxygen becomes the dominant constituent because lighter particles tend to occupy higher altitudes above the turbopause
Turbopause
The turbopause marks the altitude in the Earth's atmosphere below which turbulent mixing dominates. The region below the turbopause is known as the homosphere, where the chemical constituents are well mixed and display identical height distributions; in other words, the chemical composition of the...

 (at ~100 km). This atomic oxygen provides the O+ atomic ions that make up the F2 layer.
The F1 layer has approximately 5 × 105 e/cm3 (free electrons per cubic centimeter) at noontime and minimum sunspot
Sunspot
Sunspots are temporary phenomena on the photosphere of the Sun that appear visibly as dark spots compared to surrounding regions. They are caused by intense magnetic activity, which inhibits convection by an effect comparable to the eddy current brake, forming areas of reduced surface temperature....

 activity, and increases to roughly 2 × 106 e/cm3 during maximum sunspot activity. The density falls off to below 104 e/cm3 at night.
  • The F1 layer merges into the F2 layer at night.
  • Though fairly regular in its characteristics, it is not observable everywhere or on all days. The principal reflecting layer during the summer for paths of 2,000 to 3,500 km is the F1 layer.
  • The F2 layer exists from about 220 to 800 km above the surface of the Earth. The F2 layer is the principal reflecting layer for HF communications
    Telecommunication
    Telecommunication is the transmission of information over significant distances to communicate. In earlier times, telecommunications involved the use of visual signals, such as beacons, smoke signals, semaphore telegraphs, signal flags, and optical heliographs, or audio messages via coded...

     during both day and night. The horizon-limited distance for one-hop
    Hop (telecommunications)
    In telecommunication, the term hop has the following meanings:#The excursion of a radio wave from the Earth to the ionosphere and back to the Earth...

     F2 propagation
    Radio propagation
    Radio propagation is the behavior of radio waves when they are transmitted, or propagated from one point on the Earth to another, or into various parts of the atmosphere...

     is usually around 4,000 km. The F2 layer
    Layer
    Layer may refer to:* A layer of archaeological deposits in an excavation* A layer hen, a hen raised to produce eggs* Stratum, a layer of rock or soil with internally consistent characteristics...

    has about 106 e/cm3. However, variations are usually large, irregular, and particularly pronounced during magnetic storms. The F layer behaviour is dominated by the complex thermospheric winds.

Usage in Radio Communication

Critical F2 layer frequencies are the ones that will not go through the F2 layer.
The source of this article is wikipedia, the free encyclopedia.  The text of this article is licensed under the GFDL.
 
x
OK